Control Port Setup in Auracle X for the PlayAUDIO1U

How to setup the Auracle X Control Port Settings with Boss Foot Switches

On the foot switches

iConnectivity recommends using Boss FS-6 or Boss FS-7 foot switches with TRS cables and required pedal power supply. Please note that using Boss foot switches without their respective power supplies will disable the latching function on the pedal and force both pedals to function in momentary mode even when the pedal is set to latching.

Note: The combinations of foot switch and Auracle X configuration settings below will allow the foot switch to send one message per pedal depression. Other configurations not recommended here will result in erroneous behavior such as needing up to four pedal presses to send a message.

Auracle X Control Ports Page

FS-6

Control Port 1

A pedal corresponding to Jack 1 (Ring)

Set the FS-6 pedal mode to Latching and Auracle X Trigger type to Momentary or Set the A pedal to Momentary and Auracle X Trigger Type to Latching.

B pedal corresponding to Jack 1 (Tip)

Set the FS-6 pedal mode to Momentary and the Auracle X Trigger type to Momentary.

Control Port 2

A pedal corresponding to Jack 2 (Ring)

Set the FS-6 pedal mode to Momentary and Auracle X Trigger type to Momentary.

B pedal corresponding to Jack 2 (Tip)

Set the FS-6 pedal mode to Momentary and the Auracle X Trigger type to Momentary.

------------------------------------------------------------------------------------------------------

FS-7

Control Port 1

A pedal corresponding to Jack 1 (Ring)

Set the FS-7 pedal mode to Latching and Auracle X Trigger type to Momentary.

B pedal corresponding to Jack 1 (Tip)

Set the FS-7 pedal mode to Momentary and the Auracle X Trigger type to Momentary.

Control Port 2

A pedal corresponding to Jack 2 (Ring)

Set the FS-6 pedal mode to Momentary and Auracle X Trigger type to Momentary.

B pedal corresponding to Jack 2 (Tip)

Set the FS-6 pedal mode to Momentary and the Auracle X Trigger type to Momentary.

How to setup the Auracle X Control Port Actions

Once your foot switch and Auracle X Control Port settings are set to input and action, you can choose the message that will be sent when the foot switch is depressed. To use the connected foot switch to manually toggle the active scene (A or B) of the PlayAUDIO1U, change the Scene Change Mode parameter as seen below:

Other Control Port Actions like Arm/Disarm failover, and preset change are also available to be sent by a foot switch. You can also send MIDI notes or CC messages if  Scene Change Mode is not set to Toggle, as mentioned above in the Control Port Actions page.

Once this is done you should save both units, by double clicking the main knob on front of the PA1U interface.